Playing video:
DOWNLOADS:
Railuino™ Station V0.30 DOWNLOAD*
Railuino™ Station V0.40 DOWNLOAD*
Railuino™ Station V0.50 DOWNLOAD*
* V0.20 and V0.10 doesn't work correctly. Please download V0.30 or later.
* The source code is included in this archive. This tool uses NYSL which is similar to Creative Common Zero.
* Requires .NET framework 3.5 runtime or windows 7/8.
How to use:
0. Write "SERIAL_RS.ino" sketch to your arduino board with CAN BUS shield.
Probably, SERIAL GATEWAY sketch is on "Serial_RS.ino" included this archive. This tool is developed to apply to this sketch.
1. Connect your arduino to USB port of your windows PC.
Of course, connect Anschlussbox 60113 and your arduino with CAN BUS shield using self-made CAN cable.
I buy Seeed Studio's CAN-BUS Shield because shipping cost of watterott's CAN-diy shield is very expensive (about 30EURO!).
Arduino UNO and Seeed Studio's CAN BUS Shield:
2. Run this tool and configure serial port.
3. Press START button.
Check power on your C Track rail.
4. Edit Loc list to add your locomotives.
5. Enjoy!
Locomotive contoroller:
Turnout controller:
Don't hesitate to ask us how to use or others.
※本ソフトは海外のユーザー向けに作成しているため日本語では解説の作成優先度は低くなります。
タグ：Railuino